When Ashdown rebranded its guitar amp line as Hayden back in 2006, a few pundits were left scratching their heads.
Having built a first-class reputation with the Ashdown brand - predominantly in bass, later expanded to guitar - the company was essentially starting over with its guitar amp line.
The reasoning was that no single marque has remained fully successful in both the guitar and bass amp markets (Peavey being the exception to the rule), so after much deliberation, Hayden was born. Bass amps stayed Ashdown, guitar amps became Hayden.
Since then, the mid-price valve-amp market has been blown wide open with the introduction of Blackstar and Egnater in particular, alongside continuing development from industry big guns, Fender, Peavey, Marshall, Laney, Orange and Vox.
Hayden remains in fighting spirit, however, and now adds the new HGT-A series to its arsenal. Chief 'ears' on the project were those of Guitarist old boy/We Will Rock You stalwart and all-round awesome player, Phil Hilborne.
Hayden actually has two manufacturing bases. One is in England where ex-Matamp man Dave Green presides over the hand-built amps. The more cost-effective stuff, including these HGT series amps, are designed in the UK, but built in China. We should point out that this dual-origin arrangement led to some confusion with the MoFo series at retail, so just be sure you're buying what you think you're buying.
The 20-watt HGT-A20 combo's preamp is based around three channels - and you'll need to stay awake for this bit. The front panel knob clusters are labelled 'clean' and, 'gain one and two'. The channels meanwhile are called one, two and three, with channel selection buttons for 'one and two', and 'two and three'.
OK, so 'gain one' controls the gain in channel two, selected by pushing button 'one and two' on the front panel. Gain two controls the gain in channel three, selected by pushing 'two and three'.
According to the manual, channel three is cascaded from channel two (hence the 'two and three' designation), yet gain one - which works in channel two, you'll remember - has no effect when you're in channel three. It's much easier to think 'clean', 'crunch' and 'lead', plug in the included footswitch and twiddle the knobs until you have three sounds you like.
That, mercifully, is very simple to do - the important thing is that the crunch and lead channels have their own dedicated gain and master volume controls, so balancing gain and master across the three channels is dead easy.
In terms of tone shaping, the clean channel gets its own separate bass and treble controls, while channels two and three share theirs, plus a very powerful middle control and a contour control that has a profound effect on middle and bottom-end characteristics; more mid-scooped at one end, vocal and cutting at the other.
Additional functions are useful: the series effects loop (op-amp driven and recovered for good signal strength and ideal output impedance, according to designer Dave Green) includes a level control to bring the signal up if you're using old pedals, or those without an overall level control. There's also a pair of direct, 4 x 12 speaker-cabinet simulated recording outs; one that turns the speaker off (though you must still leave a speaker connected), and one that keeps it live.
Finally there's a digital reverb circuit included (also driven by an IC chip) that operates globally across all channels.
We can understand Hayden's decision not to go the full spring reverb route - we'd say this amp is more rock-focused than anything, where reverb is usually little more than an afterthought. Phil Hilborne preferred it this way, too.
Inside, you'll find four custom-designed, good-quality through-plated PCBs mounted solidly to a steel chassis. It's tidy, functional and easy to repair if something goes awry.
All other aspects of construction are in line with comparable products; no causes for concern with durability or protection. Particle-board cabinetry is a low-cost option, generally considered not great for tone compared with ply (Hayden's UK amps are birch ply), but if they're voiced right, it needn't be a deal breaker, especially not for heavy styles.
The open-backed combo acquits itself well on the clean channel, especially with a little reverb dialled in. The overall EQ is well balanced in, without the all-engulfing bass and lower midrange that's noticeable in its sister amp, the A40 head. The speaker feels like a good choice; it handles the power no problem.
If you're used to a quality long-tank spring reverb, this digital unit will leave you uninspired, but it's by no means all bad. It adds a decent level of ambience and air and it's at least as good as some of the more rudimentary short-tank-equipped amps we've played of late.
Channel two ups the gain and what you discover immediately is the amp's impressive response to different pickups and guitars. A single-coil Strat will reach a reasonable crunch in channel two, while more powerful humbuckers on a Les Paul, for example, push on further into warm and fat overdrive.
The HGTs have their own sound; more direct and classic rock-voiced than most Fender-derived amps; more sizzly - raspy if you're not careful - bite in the drive than modern Marshalls. We think it works better with humbuckers where there's enough power in the guitar to keep the mids and bass strong, while the treble sizzles on top.
Moving on to channel three is where the gain starts piling on. You can use the contour control to shape your sound from tighter, punchier and more vocal (good for well-controlled blues rock), though to more scooped midrange, with greater resonance and thump in the bottom end (later classic rock and on into metal). Again, it's sizzly; quite different from that some might say over-smooth Mesa- or Cornford-style heavily cascaded distortion.
The 20-watt combo is no shrinking violet. It's plenty loud enough to gig with a pub-type band, adding a more compressed, dynamic feel to notes at higher volumes.
The recording out is perfectly usable, although benefits from some judicious EQ at the desk. It's a little bit hard-sounding - exactly what you would expect of a direct out - and perhaps
not as well sorted as the Red Box DI out on Hughes & Kettner's TubeMeister series.
Much more practical is the stage/studio switch that, in the latter position, drops the output down to a whisper so you can crank it at home. It's well thought out and delivered - all amps should have one of these.
Mid-priced valve amps is an extremely tough market sector with a lot of big names. In the face of that competition, Hayden doesn't just have to be as good as the established brands, it has to make sure it's significantly better to get people to turn heads.
If you're a rock player and you want to hear a solid-gold reason to buy a Hayden, plug into the Classic Lead 80 head: it is superb. By comparison, the compromises made to hit competitive prices with this HGT series result in amps that perform well, but will struggle to distract you from the more established brands.
The one card up the sleeve is that they have their own sound that, somewhat like Blackstar, will appeal to anyone not looking for yet more traditional Fender, Vox or Marshall voicings. That may well be you.
Strong combination of gain levels and rock sounds.
Cheap cabinetry; over-complex channel set-up.
Portable and loud-for-20-watts valve combo with a wide range of sounds for classic rock and rock-leaning blues styles.
All MusicRadar's reviews are by independent product specialists, who are not aligned to any gear manufacturer or retailer. Our experts also write for renowned magazines such as Guitarist, Total Guitar, Computer Music, Future Music and Rhythm. All are part of Future PLC, the biggest publisher of music making magazines in the world.
Country of Origin
2 x direct, speaker simulated recording outputs (one silent), series effects loop with level control, stage/studio attenuation switch, digital reverb
Audio Output Power
Bass Contour Gain Master Reverb Middle Treble
All-valve combo with solid-state rectification
615 x 475 x 255