MusicRadar

Rough Rider Pro offers three bands rather than the usual four.

View in gallery

• Related News
• Review

Looking back over the list of Audio Damage releases, pretty much all of them are groundbreaking plug-ins, or at least very original takes on older ideas. The only obvious exception to this was the awesome ADverb (originally called Reverence).

However, now AD has unleashed another 'traditional' e­ffect – it's a multiband version of its acclaimed freeware compressor plug-in, Rough Rider. And, this new one has been given the Pro treatment.

Overview

At ­first glance, the familiar Audio Damage layout is evident, which is an encouraging start. Less impressive, though, are the very small interface and hard-to-read displays – this has become a worrying trend with Audio Damage.

It's easier to overlook with their more creative plug-ins, but if you can't tell whether something is -10dB or +10dB on a tiny dial, you're in trouble.

Each band has the expected compression parameters: Ratio, Attack, Release, Sensitivity (ie, threshold) and Makeup, as well as a metering section that shows the input, output and gain reduction levels.

Annoyingly, there's no bypass switch for each of the individual bands. Sure, you can set the knobs to zero to achieve the same result, but it's a ­fiddly way of doing things.

In use

Unlike many other multiband compressors, Rough Rider Pro o­ffers three bands instead of four. However, we reckon this is ample for most uses and, indeed, most users. Without prior experience, additional options can simply translate into more ways to mess things up.

So, for the best results, use the on/o­ff buttons to isolate the band you want to dial in, then use the frequency sliders to select the range (the high and low cuto­ff points define the mids), Then, adjust the settings as you would any other compressor.

The only other thing you need to worry about is whether to run things in Multi or Series mode. The former splits the three bands, processes them separately and recombines them at the output stage, while the latter sends the signal to the top band, then the middle and f­inally the bottom. Both are useful, but we found Multi mode to be very clinical, while Series is more traditional and less surgical.

We tried out Rough Rider Pro on a variety of material, including ­finished tracks ready for mastering, and found the bass frequencies to be particularly punchy.

However, the mid- and top-end started to become a little digital when pushed hard, especially when compared to really high-end multiband processors.

A quick ­lick through the presets reveals a whole range of creative uses. You can squash signals pleasantly, or drive them to distortion. For such purposes, we can't really fault it.